Physics, 08.10.2019 07:10 Savagepanda911

Question 8
4 pts
an obejct with an initial velocity of 14.7 m/s experiences a constant acceleration of 2.3 m/s2
for 2.5 seconds. during this time, how far does the object travel?
round your answer to the nearest 0.1 (tenths place). do not add units.

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 00:30

Ablock of steel has a density of 0.29lbs per cubic inch. if the block has dimensions of 1 inch by 1 inch by 3 inches, what is its weight? a. 0.29lbs b. 0.58lbs c. 0.87lbs d. 1lbs

Answers: 1

Answer

Physics, 22.06.2019 14:00

How much energy must a refrigerator absorb from 225 g of water so that the temperature of the water will drop from 35°c to 5°c

Answers: 3

Answer

Physics, 22.06.2019 14:10

Your starship, the aimless wanderer, lands on the mysterious planet mongo. as chief scientist-engineer, you make the following measurements: a 2.50-kg stone thrown upward from the ground at 14.0 m/s returns to the ground in 5.70 s ; the circumference of mongo at the equator is 2.20×10^5 km ; and there is no appreciable atmosphere on mongo. (a) the starship commander, captain confusion, asks for the following information: what is the mass of mongo? (b) if the aimless wanderer goes into a circular orbit 2.20×10^4 km above the surface of mongo, how many hours will it take the ship to complete one orbit? (c) an unmanned spacecraft is in a circular orbit around the moon, observing the lunar surface from an altitude of 44.0 km . to the dismay of scientists on earth, an electrical fault causes an on-board thruster to fire, decreasing the speed of the spacecraft by 23.0 m/s . if nothing is done to correct its orbit, with what speed (in km/h) will the spacecraft crash into the lunar surface?

Answers: 1

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

You know the right answer?

Question 8
4 pts
an obejct with an initial velocity of 14.7 m/s experiences a constant a...

Questions