Atissue cross-section viewed on a microscope slide shows a cell of almost rectangular shape with dimensions 6.9 × 10-4 cm by 1.1 × 10-3 cm. calculate the cross-sectional area of the cell. express the area in powers of ten notation and use the appropriate number of significant digits for the number multiplying the power of 10.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

d₁ = displacement of tern from arctic to antarctic = 11000 miles

d₂ = displacement of tern from antarctic to arctic =   - 11000 miles

d = total displacement for the journey

total displacement for the journey is given as

d = d₁ + d₂

d = 11000 + (-11000)

d = 0 miles

t₁ = time of travel from arctic to antarctic = 3 months = 3 x 30 days = 90 days

t₂ = time of travel from antarctic to arctic = 3 months = 3 x 30 days = 90 days

t = total time of travel

total time of travel is given as

t = t₁ + t₂

t = 90 + 90

t = 180 days

average velocity is given as

average velocity = total displacement/ total time

v = d/t

v = 0/180

v = 0 miles/day

talk back to him about the sport and show him your expertise or leave the room

pecialized keyboards