Dona rolls a marble with a speed of 5.0/m/s across a level table that is 1.6m above the floor. upon reaching the edge of the table it follows a parabolic path to the floor . how far does the marble travel in the x direction

We have that for the Question "Dona rolls a marble with a speed of 5.0/m/s across a level table that is 1.6m above the floor" it can be said that the travel in the x direction is

x'=2.85m

From the question we are told

Dona rolls a marble with a speed of 5.0/m/s across a level table that is 1.6m above the floor. Upon reaching the edge of the table it follows a parabolic path to the floor . How far does the marble travel in the x direction

Generally the equation for the kinematic equation  is mathematically given as

t=0.57s

Therefore

The Horizontal distance

x'=2.85m

For the QUestion"How far does the marble travel in the x direction"

x'=2.85m

For more information on this visit

link

2.9 m

Explanation:

First find the time it takes to reach the floor.

y = y₀ + v₀ t + ½ at²

(0 m) = (1.6 m) + (0 m/s) t + ½ (-9.8 m/s²) t²

t = 0.571 s

Next, find the distance it travels in that time.

x = x₀ + v₀ t + ½ at²

x = (0 m) + (5.0 m/s) (0.571 s) + ½ (0 m/s²) (0.571 s)²

x = 2.86 m

Rounded to two significant figures, the marble travels 2.9 meters in the x direction.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

car a and b are moving in opposite directions

plz mark.me the brainliest i rlly need this kind of yours in exchange