The total consumption of electrical energy in the united states is about 1.0 1019 joules per year.
(a) what is the average rate of electrical energy consumption?
b) the population of the united states is about 300 million people. what is the average rate of electrical energy consumption per person?
c) the sun transfers energy to the earth by radiation at a rate of approximately 1.0 kw per square meter of surface. if this energy could be collected and converted to electrical energy with 85% efficiency, how great an area (in square kilometers) would be required to collect the electrical energy used in the united states?

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

Cathy is pedaling down a steep hill on her bicycle and wants to be able to coast up the next hill, which is 25 meters high, without pedaling. cathy and her bicycle have a mass of 75 kg. assuming her bicycle is 100% efficient, what would her speed have to be?

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)