subject
Physics, 20.11.2019 21:31 Toady8432

For a particular semiconductor, eg = 1.50 ev, m p* = 10 mn* , t = 300 k, and ni = 1 x 105 cm^-3.

(a) determine the position of the intrinsic fermi energy level with respect to the center of the bandgap.

(b) impurity atoms are added so that the fermi energy level is 0.45 ev below the center of the bandgap.

(i) are acceptor or donor atoms added?

(ii) what is the concentration of impurity atoms added

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
1. consider the case in which air fills air shocks on a truck trailer. the pressure in the shocks is 2 mpa. the temperature is 300 k. the diameter of the shock piston is 10 cm and the initial length of the cylindrical cavity containing the compressed air is 40 cm. a. the truck is gradually loaded over a period of a day in a static setting. the temperature is held constant for the atmosphere and thus for the gas shock. calculate the compressibility of the air in the shock for this condition when the truck is initially being loaded. b. if the shocks were loaded in a dynamic setting by driving over bumps, what would be the compressibility? state your assumption. c. what is the initial load on the shock if the shock is in an atmospheric 100 kpa? d. if the shock is compressed using the process described in part a, and the air shock compressed air cavity length decreases to 20 cm, what is the additional load applied to the shock?
Answers: 2
question
Physics, 22.06.2019 13:30
6–43 a food department is kept at 2128c by a refrigerator in an environment at 308c. the total heat gain to the food department is estimated to be 3300 kj/h and the heat rejection in the condenser is 4800 kj/h. determine the power input to the compressor, in kw and the cop of the refrigerator.
Answers: 2
question
Physics, 22.06.2019 15:00
Amoving company collects data about couches they move and displays the data in a table. the force along the ramp, the angle of the ramp, and the height the couch is raised to are shown. which statements correctly compare the work done to move the couches? check all that apply. the same amount of work is done for couches 1 and 3. the same amount of work is done for couches 2 and 3. the work for couch 1 is greater than the work for couch 2. the work for couch 2 is less than the work for couch 3. the work for couch 3 is greater than the work for couch 1. the work for couch 2 is greater than the work for couch 1.
Answers: 1
question
Physics, 22.06.2019 20:30
Aball is thrown from the top of a building with an initial velocity of 21.9 m/s straight upward, at an initial height of 51.6 m above the ground. the ball just misses the edge of the roof on its way down, as shown in the figure. (a) determine the time needed for the ball to reach its maximum height. (b) determine the maximum height. (c) determine the time needed for the ball to return to the height from which it was thrown, and the velocity of the ball at that instant. (d) determine the time needed for the ball to reach the ground. (e) determine the velocity and position of the ball at t = 5.35 s.
Answers: 1
You know the right answer?
For a particular semiconductor, eg = 1.50 ev, m p* = 10 mn* , t = 300 k, and ni = 1 x 105 cm^-3.
Questions
Questions on the website: 13722360