subject
Physics, 22.11.2019 20:31 pulpfree8057

Abungee jumper with mass 64.0 kg jumps from a high bridge. after reaching his lowest point, he oscillates up and down, hitting a low point eight more times in 50.0 s . he finally comes to rest 30.0 m below the level of the bridge. estimate the spring stiffness constant and the unstretched length of the bungee cord assuming shm.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 17:20
American eels (anguilla rostrata) are freshwater fish with long, slender bodies that we can treat as uniform cylinders 1.0 m long and 10 cm in diameter. an eel compensates for its small jaw and teeth by holding onto prey with its mouth and then rapidly spinning its body around its long axis to tear off a piece of flesh. eels have been recorded to spin at up to 14 revolutions per second when feeding in this way. although this feeding method is costly in terms of energy, it allows the eel to feed on larger prey than it otherwise could. 1.a field researcher uses the slow-motion feature on her phones camera to shoot a video of an eel spinning at its maximum rate. the camera records at 120 frames per second. through what angle does the eel rotate from one frame to the next? 2. the eel is observed to spin at 14 spins per second clockwise, and 10 seconds later it is observed to spin at 8 spins per second counterclockwise. what is the magnitude of the eels average angular acceleration during this time? 3. the eel has a certain amount of rotational kinetic energy when spinning at 14 spins per second. if it swam in a straight line instead, about how fast would the eel have to swim to have the same amount of kinetic energy as when it is spinning? 4.a new species of eel is found to have the same mass but one-quarter the length and twice the diameter of the american eel. how does its moment of inertia for spinning around its long axis compare to that of the american eel?
Answers: 1
question
Physics, 22.06.2019 15:30
At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.
Answers: 1
question
Physics, 22.06.2019 15:30
1kg of water needs to recieve 4200j of energy to go from 90 degrees to 91 degrees. what is the specific heat capacity of water? what are the units?
Answers: 1
question
Physics, 22.06.2019 16:00
The electric field direction is defined by the direction of the force felt by (select one of the following answers): 1. a negative charge. 2. a positive charge. 3. both positive and negative charges.
Answers: 2
You know the right answer?
Abungee jumper with mass 64.0 kg jumps from a high bridge. after reaching his lowest point, he oscil...
Questions
question
Social Studies, 17.03.2020 22:08
question
English, 17.03.2020 22:08
question
Mathematics, 17.03.2020 22:08
question
Mathematics, 17.03.2020 22:09
question
Mathematics, 17.03.2020 22:09
Questions on the website: 13722360