Physics, 25.11.2019 23:31 toxsicity

Acar moving at 10 m/s crashes into a large bush and stops in 1.3 m. using the work-energy theorem, calculate the average force the seat belt exerts on a passenger in the car to bring him to a halt. the mass of the passenger is 70 kg. how long does this take?

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 10:00

How many times did thomas edison mess up the light bulb

Answers: 1

Answer

Physics, 22.06.2019 11:00

Looking at this barometer, is the air pressure high or low? what type of weather would you expect? high, bad low, bad high, good low, good

Answers: 1

Answer

Physics, 22.06.2019 23:00

Imagine an isolated positive point charge q (many times larger than the charge on a single proton). there is a charged particle a (whose charge is much smaller than charge q) at a distance from the point charge q. on which of the following quantities does the magnitude of the electric field created by charge q at particle a's position depend? check all that apply.the type of the charge on the charged particle athe relative orientation between q and a (while the distance between q and a is fixed)the specific location of the charged particle a (while the distance between q and a is fixed)the amount of the charge on the point charge qthe specific location of the point charge q (while the distance between q and a is fixed)the distance between the point charge q and the charged particle athe amount of the charge on the charged particle a

Answers: 3

Answer

Physics, 23.06.2019 02:10

Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.

Answers: 1

Answer

You know the right answer?

Acar moving at 10 m/s crashes into a large bush and stops in 1.3 m. using the work-energy theorem, c...

Questions