Physics, 27.11.2019 19:31 lucifer6669

Shows a boom and tie-rod arrangement supporting a load of 6 kn. the tie-rod is made of steel having a tensile yield strength of 400 mpa. (a) what is the safety factor of the tie-rod with respect to static yielding? (b) what is the safety factor of the tie-rod if the vertical rod is rotated 180° so that the 6-kn load acts upward?

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 21:30

Apendulum has a mass of 1.5 kg and starts at a height of 0.4 m. if it is released from rest, how fast is it going when it reaches the lowest point of its path? acceleration due to gravity is g = 9.8 m/s2. a. 2.8 m/s b. 0 m/s c. 5.9 m/s d. 4.3 m/s

Answers: 1

Answer

Physics, 22.06.2019 19:30

Water is siphoned from a large tank and discharges into the atmosphere through a 50-mm diameter tube. the end of the tube is b = 2.6 m below the tank bottom which is a = 6.7 m deep, and viscous effects are negligible. determine the maximum height h over which the water can be siphoned without cavitation occurring. atmospheric pressure is 101.4 kpa, and the water vapor pressure is 1.79 kpa (absolute). report your answer in meters to two decimal places.

Answers: 1

Answer

Physics, 23.06.2019 08:00

Athin electrical heater is inserted between a long circular rod and a concentric tube with inner and outer radii of 20 and 40 mm. the rod (a) has a thermal conductivity of ka = 0.15 w/(m*k), while the tube (b) has a thermal conductivity of kb = 0.8 w/(m*k) and its outer surface is subjected to convection with a fluid of temperature t= -15°c and heat transfer coefficient 60 w/(m2 *k). the thermal contact resistance between the cylinder surfaces and the heater is negligible. (a) determine the electrical power per unit length of the cylinders (w/m) that is required to maintain the outer surface of cylinder b at 15°c. (b) what is the temperature at the center of cylinder a?

Answers: 2

Answer

Physics, 23.06.2019 14:00

Veronica’s velocity was measured as 4.3 m/s. she displaced 20 meters in 4.7 seconds. which piece of information is missing for the correct calculation of velocity? the starting point the direction the end point the time per meter

Answers: 3

Answer

You know the right answer?

Shows a boom and tie-rod arrangement supporting a load of 6 kn. the tie-rod is made of steel having...

Questions