Which of the following materials has the lowest resistance copper wood plastic

The ballistic pendulum was invented in 1742 by english mathematician benjamin robins. it consists of an initially stationary pendulum that moves after being struck by a bullet, and it is used to measure the original velocity of the bullet. the known variables are the bullet's mass m, the pendulum's mass m, and the height to which the block and bullet swing, determined by the length of the pendulum l and final angle θ. two principles of physics are necessary to solve for the bullet's original velocity. what are these principles? conservation of momentum and newton's third law conservation of energy and conservation of angular momentum grade summary deductions 0% potential 100% conservation of momentum and newton's second law. newton's second law and conservation of angular momentum. conservation of energy and newton's third law conservation of momentum and conservation of angular momentum. conservation of momentum and conservation of energy conservation of energy and newton's second law.

In the 1980's, congress authorized the u.s. department of energy to build the wipp facility in the chicuahuan desert in new mexico. what is the purpose of wipp?

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.