Physics, 04.12.2019 22:31 Jasten

What is it called when earth’s magnetic poles change places?
a.
a strike-slip fault
c.
sea-floor spreading
b.
magnetic reversal
d.
continental drift

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 03:10

Athin plate moves between two parallel, horizontal, stationary flat surfaces at a constant velocity of v = 7.5 m/s. the two stationary surfaces are spaced 4 cm apart, and the medium between them is filled with oil whose viscosity is 0.9 n·s/m2. the part of the plate immersed in oil at any given time is 2 m long and 0.5 m wide. if the plate moves through the mid-plane between the surfaces, determine the force required to maintain this motion. what would your response be if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top surface (h1)? if the plate moves through the mid-plane between the surfaces, the force required to maintain the motion will be n. if the plate was 1 cm from the bottom surface (h2) and 3 cm from the top (h1) surface, the force required to maintain the motion would be n.

Answers: 2

Answer

Physics, 22.06.2019 22:20

Which symbol in the first law of thermodynamics represents the sum of the chemical and thermal energy stored in atoms and molecules? a. q b.w c.v d.u

Answers: 3

Answer

Physics, 23.06.2019 02:10

Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.

Answers: 1

Answer

Physics, 23.06.2019 03:00

Use the library or internet to research each planet. make a chart comparing the following: approximate surface temperature relative surface gravity compared to earth atmospheric gases water in any form: solid, gas, or liquid when you have completed your chart, use the information you have collected to answer the following questions: which is the hottest planet? which is the coldest planet? which planet's temperature is closest to that of earth? (note: water boils at 100°c/212°f. water freezes at 0°c/32°f) which planet has the greatest gravitational attraction? which planet has the least gravitational attraction? which planet's gravitational pull is closest to that of earth? do any of the planets have oxygen in their atmosphere? which planet's atmosphere most resembles that of earth? do any of the planets have flowing water? which planet's water resources (solid, gas, or liquid) might be close to the amount on earth? which planet most resembles earth in terms of all of the factors: temperature, gravity, atmosphere, and water? if earth became an uninhabitable planet, which planet do you think would be the next best to live on? explain your answer.

Answers: 2

Answer

You know the right answer?

What is it called when earth’s magnetic poles change places?
a.
a strike-slip fault

Questions