Physics, 05.12.2019 21:31 jzjzjzj

What is the new acceleration (in m/s/s)?

Answers: 2

Show answers

Answers

Answer from: Quest

elly's long hair:

a. if the salon only takes cash, then this isn't the problem. it doesn't matter how much she has in her checking account. she can't get a haircut until she has the cash.

b. if she has overdraft protection, then there's no problem. she can go ahead and write a check that her account can't cover, then sometime later, pay the bank some outrageous usury for loaning her a few bucks for a few days, but with beautiful hair.

c. if elly has some principles, and doesn't want to write a bad check, then now she has a problem. her desire for the new hairstyle is in conflict with her honesty and integrity.

d. if the bank will not process a check she writes, then even if she had a million $$ in her account, she couldn't use any of it. the amount she has in her account is not the problem. and if i may suggest, she might as well close her checking account, and put the money where it'll work for her. it's not doing her a bit of good in a checking account, since she can't write any checks.

justin can't pay the full balance:

a. he can't even handle the credit limit he has now. under no circumstances should he ask for a higher limit.

b. he can ask for the grace period to be extended. but that's no solution, the bank will almost certainly refuse anyway, and there are much better options. he knew the rules of his credit card when he started using it.

c. he definitely should pay the interest on the balance, plus as much of the balance as he can cover at the same time.

d. he definitely should pay the minimum otherwise they could shut down his card. he should also pay as much more as he possibly can. he should also remember the awkward situation he's in, stop buying stuff on credit that he can't afford, and avoid adding any more debt.

i'd say that justin's best best option isn't on this list of choices. what he has to do: pay as much as he can at least the minimum payment plus as much more as he can and then avoid adding more debt.

Answer from: Quest

resonant frequency

Answer from: Quest

see earlier

Answer from: Quest

i think it's 35 meters

Another question on Physics

Physics, 21.06.2019 22:50

Two horizontal plates with infinite length and width are separated by a distance h in the z direction. the bottom plate is moving at a velocity u. the incompressible fluid trapped between the plates is moving in the positive x-direction with the bottom plate. align gravity with positive z. assume that the flow is fully-developed and laminar. if the systems operates at steady state and the pressure gradient in x-direction can be ignored, do the following: 1. sketch your system 2. identify the coordinate system to be used. 3. show your coordinates and origin point on the sketch. list all your assumptions. 5. apply the continuity equation to your system. nts of navier stokes equations of choice to your system 7. solve the resulting differential equation to obtain the velocity profile within the system make sure to list your boundary conditions. check units of velocity 8. describe the velocity profile you obtain using engineering terminology. sketch that on the same sketch you provided in (1). 9. obtain the equation that describes the volumetric flow rate in the system. check the units.

Answers: 2

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

Physics, 22.06.2019 15:30

Ametal ring 4.20 cm in diameter is placed between the north and south poles of large magnets with the plane of its area perpendicular to the magnetic field. these magnets produce an initial uniform field of 1.12 t between them but are gradually pulled apart, causing this field to remain uniform but decrease steadily at 0.240 t/s . (a) what is the magnitude of the electric field induced in the ring? (b) in which direction (clockwise or counterclockwise) does the current flow as viewed by someone on the south pole of the magnet?

Answers: 2

Answer

Physics, 22.06.2019 17:30

Atruck driver is attempting to deliver some furniture. first, he travels 8 km east, and then he turns around and travels 3 km west. finally, he turns again and travels 13 km to his destination. what is the drivers total displacement?