Two technicians are discussing a stepped ect circuit. technician a says that the sensor used for a stepped circuit is different from the one used in a non-stepped circuit. technician b says that a stepped ect circuit uses different internal resistance inside the pcm. who is right?

An internally reversible refrigerator has a modified coefficient of performance accounting for realistic heat transfer processes of where qin is the refrigerator cooling rate, qout is the heat rejection rate, and is the power input. show that copm can be expressed in terms of the reservoir temperatures tc and th, the cold and hot thermal resistances rt,c and rt,h, and qin, as where rtot rt,c rt,h. also, show that the power input may be expressed as 1.39 a household refrigerator operates with cold- and hot-temperature reservoirs of tc 5 c and th 25 c, respectively. when new, the cold and hot side resistances are rc,n 0.05 k/w and rh,n 0.04 k/w, respectively. over time, dust accumulates on the refrigerator’s condenser coil, which is located behind the refrigerator, increasing the hot side resistance to rh,d 0.1 k/w. it is desired to have a refrigerator cooling rate of qin 750 w. using the results of problem 1.38, determine the modified coefficient of performance and the required power input w under (a) clean and (b) dusty coil conditions. internally reversible refrigerator qout qin w high-temperature reservoir low-temperature reservoir th th,i tc,i tc high-temperature side resistance low-temperature side resistance w qin th tc qinrtot tc qinrtot copm tc qinrtot th tc

What is a subatomic particle with a negative charge and very little mass?

1. what is the relationship between wavelength and the penetrating power of an electromagnetic wave? a) the penetrating power has no relationship to the wavelength. b) the penetrating power increases as the wavelength increases. c) the penetrating power decreases as the wavelength increases. d) the penetrating power decreases as the wavelength decreases. 2. as ice melts and turns into water, the speed of sound through the material would most likely do what? justify your answer. a) the speed would not change because the material is always water. b) the speed of sound would increase because the density of water is less than that of ice. c) the speed of sound would increase because energy is added to ice in order to make it melt. d) the speed of sound would decrease because sound travels faster through solids than liquids. 3.which of these waves need a medium to travel through? a) sound b) x-rays c) infrared rays d) visible light