The coolant heat storage system is being discussed. technician a says that the water valve is driven by an electric motor. technician b says that the storage tank has its own electric water pump. which technician is correct?

Ahorizontal wire is tied to supports at each end and vibrates in its second-overtone standing wave. the tension in the wire is 5.00 n, and the node-to-node distance in the standing wave is 6.28 cm. (a) what is the length of the wire? (b) a point at an anti- node of the standing wave on the wire travels from its maximum upward displacement to its maximum downward displacement in 8.40 ms. what is the wire's mass?

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Industrial processes often require the damping of vibrations. consider a workbench that uses four large ideal springs in place of traditional legs, with each spring supporting one corner of the workbench and exhibiting a force constant of 47500 n/m. this workbench is used when creating products that involve highly unstable chemicals. according to specifications, the acceleration of the manufacturing equipment must be held to less than 22.3 m/s2 for the manufacturing process to proceed safely. the amplitude of vibrations are expected to remain under 0.622 mm throughout. given that the workbench and maufacturing equipment combine to 6.05 kg, find the maximum acceleration expected of the equipment and workbench. (ignore the mass of the springs.)