Physics, 09.01.2020 04:31 wiljoystoltz253

An ore sample weighs 17.50 n in air. when the sample
issuspended by a light cord and totally immersed in water,
thetension in the cord is 11.20 n. find the total volume and
thedensity of the sample.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

Physics, 22.06.2019 16:00

Amichelson interferometer operating at a 600 nm wavelength has a 3.02-cm-long glass cell in one arm. to begin, the air is pumped out of the cell and mirror m2 is adjusted to produce a bright spot at the center of the interference pattern. then a valve is opened and air is slowly admitted into the cell. the index of refraction of air at 1.00 atm pressure is 1.00028.how many bright-dark-bright fringe shifts are observed as the cell fills with air?

Answers: 1

Answer

Physics, 22.06.2019 16:40

The astronauts on the space shuttle flights experienced an acceleration of 29 m/s2 (about 3 "g's") during lift-off. what upward force must the astronaut's seat apply to the astronaut in order to cause this acceleration? assume the astronaut's mass is 70 kg, and compute this force when the acceleration is near the earth's surface so their weight equals latex: mg m g .

Answers: 3

Answer

Physics, 23.06.2019 02:30

Ball bearings are made by letting spherical drops of molten metal fall inside a talll tower-called a shot tower- and solidify as they fall. a-if a bearing needs 4.0 s to solidify enough for impact, how high must the tower be? b- what is the bearing's impact velocity?

Answers: 3

Answer

You know the right answer?

An ore sample weighs 17.50 n in air. when the sample
issuspended by a light cord and totally i...

Questions