Physics, 09.01.2020 05:31 priceisright11401

Aperson is standing on a level floor. his head, upper
torso, arms, and hands together weigh 438 n and have a center of
gravitythat is 1.28 m above the floor. his upper legs weigh 144 n
and havea center of gravity that is 0.760 m above the floor.
finally, hislower legs and feet together weigh 87 n and have a
center ofgravity that is 0.250 m above the floor. relative to the
floor, find the location of the center of gravity for the
entirebody.

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 22:00

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

Answers: 2

Answer

Physics, 22.06.2019 08:00

What is a carrier wave and how does it affect what you hear on the radio

Answers: 1

Answer

Physics, 22.06.2019 09:30

Which are advantages of renewable resources? check all that apply. renewable energy supplies are completely reliable everywhere. some renewable resources will never be used up. little or no waste is produced by renewable resource plants. electricity can be generated in large quantities. many renewable energy facilities have lower operating costs.

Answers: 1

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

You know the right answer?

Aperson is standing on a level floor. his head, upper
torso, arms, and hands together weigh 43...

Questions