Light-rail passenger trains that provide transportation within and between cities speed up and slow down with a nearly constant (and quite modest) acceleration. a train travels through a congested part of town at 7.0 m/s . once free of this area, it speeds up to 13 m/s in 8.0 s. at the edge of town, the driver again accelerates, with the same acceleration, for another 16 s to reach a higher cruising speed?

25 m/s

Explanation:

from the question you van see that some detail is missing, however i found this same question using internet search engines on: 'https://www.chegg.com/homework-help/questions-and-answers/light-rail-passenger-trains-provide-transportation-within-cities-speed-slow-nearly-constan-q5808369'

here is the complete question:

'Light-rail passenger trains that provide transportation within and between cities speed up and slow down with a nearly constant (and quite modest) acceleration. A train travels through a congested part of town at 7.0m/s . Once free of this area, it speeds up to 12m/s in 8.0 s. At the edge of town, the driver again accelerates, with the same acceleration, for another 16 s to reach a higher cruising speed. What is the final Speed?'

SOLUTION

initial speed (u) = 7 m/s

final speed (v) = 13 m/s

initial acceleration time (t1) = 8 s

final acceleration time (t2) = 16 s

what is the higher cruising speed?

acceleration =

acceleration = = 0.75 m/s^{2}

since the train accelerates at the same rate, the increase in  speed will be = acceleration x time (t2)

= 0.75 x 16 = 12 m/s

therefore the higher cruising speed = increase in speed + initial speed

= 12 + 13 = 25 m/s

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

answer: strength i guess

explanation: