subject
Physics, 12.02.2020 05:30 crosales102

A cylindrical rod of stainless steel is insulated on its exterior surface except for the ends. The steady-state temperature distribution is T(x)=a-bx/L, where a=305K and b=10K. The diameter and the length of the rod are D=20 mm and L = 100 mm, respectively. Determine the flux along the rod 푞"푥. Hint: The mass of the rod is m=0.248 kg.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 19:00
When the velocity of an object is doubled, by what factor is its momentum changed? by what factor is its kinetic energy changed? a) the momentum is zero. b) the momentum is not zero. c) difficult to say.
Answers: 3
question
Physics, 22.06.2019 17:30
Students in an introductory physics lab are performing an experiment with a parallel-plate capacitor made of two circular aluminum plates, each 11 cm in diameter, separated by 1.0 cm. how much charge can be added to each of the plates before a spark jumps between the two plates? for such flat electrodes, assume that value of 3×106n/c of the field causes a spark.
Answers: 2
question
Physics, 22.06.2019 18:00
Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)
Answers: 3
question
Physics, 22.06.2019 18:50
Avertical clean glass piezometer tube has an inside diameter of d = 1 mm and is used to measure pressure in a horizontal pipe carrying water as shown. due to pressure in the pipe, the water at 20c rises into the tube to a height h. if the water pressure in the pipe is p = 500 pa gauge, estimate the height h: (a) without considering surface tension (b) with surface tension (capillary) effects. the contact angle  can be assumed at 30 deg
Answers: 2
You know the right answer?
A cylindrical rod of stainless steel is insulated on its exterior surface except for the ends. The s...
Questions
Questions on the website: 13722361