These are equal and opposite forces that do not cause a change in position or motion.

Balanced forces.

Explanation:

Forces that are opposite in direction, and, equal in size do not cause a change in motion or position are known as balanced forces. When it is applied to an object at rest, the object will not show any movement.

A good example of a balanced force is when we are trying to push a wall, the wall will push back with an opposite but equal force, so, this time neither the wall nor you will move.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

luster is not a good characteristic to use by itself because luster is the property of minerals that indicates how much the surface of a mineral reflects light. the luster of a mineral is affected by the brilliance of the light used to observe the mineral surface.