subject
Physics, 21.02.2020 19:34 allisonpierce1787

6. A roller coaster is designed so that the car is pulled up to the top of the first hill by a chain and
pulley system. After that, however, the car coasts the rest of the way through the track, never being
pulled or pushed again until its brakes stop it. Under these conditions, what is wrong with the roller
coaster designed below?

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 18:10
Awheelhas a radius of 4.8 m. howfar (path length) does a point on the circumference travel if thewheel is rotated through angles of 30°, 30 rad, and 30 rev,respectively?
Answers: 3
question
Physics, 22.06.2019 00:10
The energy released by a chemical reaction can be measured using a calorimeter. when barium hydroxide octahydrate crystals are reacted with dry ammonium chloride inside of a coffee cup calorimeter, the temperature of the 18.00 g of water in the calorimeter decreases from 30.0°c to 8.0°c. the equation for calculating energy absorbed or released by a reaction is: where q is the energy released or absorbed, m is the mass of water in the calorimeter, cp is the specific heat of water, and δt is the observed temperature change. if the specific heat of liquid water is 4.19 j/g·°c, how much energy was absorbed by the reaction?
Answers: 3
question
Physics, 22.06.2019 07:40
Astudent creates a model of a closed ecosystem by filling a glass tank half full with water, then adding 10 snails and two small aquatic plants. the next day, all the snails are dead. what is the most likely cause of their death?
Answers: 3
question
Physics, 22.06.2019 08:20
A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?
Answers: 3
You know the right answer?
6. A roller coaster is designed so that the car is pulled up to the top of the first hill by a chain...
Questions
question
Computers and Technology, 01.08.2019 08:30
Questions on the website: 13722363