Physics, 24.02.2020 04:58 jurnee77

The graph in the figure shows the x component f of the net force that acts for 10 s on a 100 kg crate what is the change in momentum

Answers: 2

Show answers

Answers

Answer from: Quest

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

Answer from: Quest

learn it on the intertant so you can solve

Answer from: Quest

vapour or gas assuming atmospheriv pressure

Answer from: Quest

d₁ = displacement of tern from arctic to antarctic = 11000 miles

d₂ = displacement of tern from antarctic to arctic = - 11000 miles

d = total displacement for the journey

total displacement for the journey is given as

d = d₁ + d₂

d = 11000 + (-11000)

d = 0 miles

t₁ = time of travel from arctic to antarctic = 3 months = 3 x 30 days = 90 days

t₂ = time of travel from antarctic to arctic = 3 months = 3 x 30 days = 90 days

t = total time of travel

total time of travel is given as

t = t₁ + t₂

t = 90 + 90

t = 180 days

average velocity is given as

average velocity = total displacement/ total time

v = d/t

v = 0/180

v = 0 miles/day

Another question on Physics

Physics, 22.06.2019 06:00

Suppose water is leaking from a tank through a circular hole of area ah at its bottom. when water leaks through a hole, friction and contraction of the stream near the hole reduce the volume of water leaving the tank per second to cah 2gh , where c (0 < c < 1) is an empirical constant. a tank in the form of a right-circular cone standing on end, vertex down, is leaking water through a circular hole in its bottom. (assume the removed apex of the cone is of negligible height and volume.) (a) suppose the tank is 20 feet high and has radius 8 feet and the circular hole has radius 2 inches. the differential equation governing the height h in feet of water leaking from a tank after t seconds is dh dt = − 5 6h3/2 . if the height of the water is initially 8 feet, how long will it take the tank to empty? (round your answer to two decimal places.)

Answers: 2

Answer

Physics, 22.06.2019 20:50

An ideal otto cycle has a compression ratio of 8. at the beginning of the compression process, air is at 95 kpa and 27°c, and 750 kj/kg of heat is transferred to air during the constant-volume heat-addition process. assuming constant specific heats at room temperature, determine (a) the pressure and temperature at the end of the heat-addition process, (b) the net work output, (c) the thermal efficiency, and (d) the mean effective pressure for the cycle. (4390 kpa, 1730 k; 423 kj/kg; 56.4%; 534 kpa)

Answers: 1

Answer

Physics, 23.06.2019 02:00

Does the asteroid belt revolve around the sun?

Answers: 2

Answer

Physics, 23.06.2019 04:00

Can anyone plz answer any of these. even if its one it will

Answers: 1

Answer

You know the right answer?

The graph in the figure shows the x component f of the net force that acts for 10 s on a 100 kg crat...