subject
Physics, 02.10.2019 07:30 hebrew1148

Is the combination of two nuclei to produce a nucleus of heavier mass.
a. fission
b. nuclear radiation
c. radioactivity
d. fusion

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 18:10
Scientists use laser range-finding to measure the distance to the moon with great accuracy. a brief laser pulse is fired at the moon, then the time interval is measured until the "echo" is seen by a telescope. a laser beam spreads out as it travels because it diffracts through a circular exit as it leaves the laser. in order for the reflected light to be bright enough to detect, the laser spot on the moon must be no more than 1.0 km in diameter. staying within this diameter is accomplished by using a special large-diameter laser. part a if λ = 540nm , what is the minimum diameter of the circular opening from which the laser beam emerges? the earth-moon distance is 384,000 km. express your answer to two significant figures and include the appropriate units.
Answers: 1
question
Physics, 21.06.2019 22:50
Acar of mass m goes around a banked curve of radius r with speed v. if the road is frictionless due to ice, the car can still negotiate the curve if the horizontal component of the normal force on the car from the road is equal in magnitude to 101) a) mv2/r b) mg/2. d) mg e) tan[v2/(eg)]
Answers: 2
question
Physics, 22.06.2019 01:10
Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)
Answers: 3
question
Physics, 22.06.2019 22:00
Hat is the most commonly cited cause of occupational injuries in the healthcare sector? a. repositioning of patients b. manual pipetting c. slips and trips d. workplace violence
Answers: 3
You know the right answer?
Is the combination of two nuclei to produce a nucleus of heavier mass.
a. fission
b. nuc...
Questions
question
Mathematics, 20.09.2020 18:01
question
English, 20.09.2020 18:01
question
Mathematics, 20.09.2020 18:01
Questions on the website: 13722367