Imagine two people standing at placemark A and placemark E, looking at each other across the fault. Which of the following statements correctly describes the relative motion of the land opposite each observer?

a. To both observers, the land opposite them is moving to the right.
b. To both observers, the land opposite them is moving to the left.
c. To the observer at placemark A, the land at placemark Eis moving to the left
d. To the observer at placemark E, the land at placemark A is moving to the right.

To both observers, the land opposite them is moving to the right.

Explanation:

I have this class too. and there is also a quizlet with all the answers to the rest of the other questions. Trust me its right .

https://quizlet.com/261219090/oce-1001-chapter-2-flash-cards/

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

depends on what you mean by "group." for order, it would be coleoptera (beetles). for class, it would be insecta (insects). for phylum, it would be the arthropoda (animals with jointed exoskeletons).

explanation: