A hair dryer draws a current of 14.5 A . How many minutes does it take for 7.9 × 103 C of charge to pass through the hair dryer? The fundamental charge is 1.602 × 10−19 C . Answer in units of min.

What elements are found in the inner and out core of the earth? the correct layers of earth's interior from the top to the center? what is the unwanted material that is removed from a mine called? how much stronger is an earthquake that registers 5 on the richter as opposed to 2? what occurs at a convergence plate boundary? the majority of the the earth's rock what is the most common element found in the earth's crust? what element is found in pyrite that contributes to acid mine drainage? why must mining companies post bond prior to permitting? how are bacteria being used in treating effluent from mines? what is a problem of acid mine drainage in rivers and soils? what do tectonic plates move on? why is gold smelting so damaging? how are artesian wells formed? where is dammed water colder than the river it flows into? what is one of the problems of uncontained aqueducts? what is the largest use of industrial water? underground sand and gravel formations that can store water? what type of water test measure acidity? which type of water test for cloudiness from suspended solids? what water test measures the amount of calcium and magnesium? these are all problems of coal power plants all of the following are advantages of riparian lands along rivers what type of water would be the warmest and have the least amount of dissolved oxygen? the zone of aeration is

In science and physics what is the standard unit of measure for speed?

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)