Water flows without friction vertically downward through a pipe and enters a section where the cross sectional area is larger. The velocity profile is uniform at sections 1 and 2. The correct statement about the static pressure p2 relative to p1 and the velocity V2 relative to V1 along the streamline down the center of the pipe is

will be less than and will be greater than .

Explanation:

As we know from the conservation of mass, the rate at which any amount of fluid mass () is entering in a system is equal to the rate at which the same amount of fluid mass () is leaving the system.

Rate of mass flow can be written as,

where is the density of the fluid, is the area through which the fluid is flowing and is the velocity of the fluid.

Now, according to the problem, as the density of the fluid does not change, we can write

where and are the cross-sectional areas through which the fluid is passing and and are the velocities of the fluid through the respective cross-sectional areas.

As according to the problem, , so from the above formula .

Also we know that fluid pressure is created by the motion of the fluid through any area. When the fluid gains speed, some of its energy is used to move faster in the fluid’s direction of motion. It causes in a lower pressure.

So, as in this case the pressure in the large cross-sectional area will be greater than the pressure   in the small cross sectional area, i.e.,

.

explanation:

areas w steep slopes, west coast, rocky mountains, and appalachian mountains

nah.   i'm just sleepy.