Physics, 10.03.2020 18:02 kingamir

Two cars are driving at the same constant speed v around a racetrack. However, they are traveling through turns that have different radii, as shown in the drawing. Which statement is true about the magnitude of the centripetal acceleration of each car?

A. The magnitude of the centripetal acceleration of the car at A is less than that of the car at B, since the radius of the circular track is smaller at A.
B. The magnitude of the centripetal acceleration of the car at A is greater than that of the car at B, since the radius of the circular track is greater at A.
C. The magnitude of the centripetal acceleration of each car is the same, since the cars are moving at the same speed.
D. The magnitude of the centripetal acceleration of the car at A is greater than that of the car at B, since the radius of the circular track is smaller at A

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 01:00

When you turn on a battery-operated device, an electrical circuit is

Answers: 1

Answer

Physics, 22.06.2019 02:50

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)

Answers: 3

Answer

Physics, 22.06.2019 03:50

The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error

Answers: 1

Answer

Physics, 22.06.2019 06:00

Using a pedometer, you walk 3000 steps in 20 minutes, so your speed is 150 steps/min. each of your steps is 0.7 m long. what is your speed? 150 steps/min=/s=/h

Answers: 1

Answer

You know the right answer?

Two cars are driving at the same constant speed v around a racetrack. However, they are traveling th...

Questions