A flat sheet of paper of area 0.250 m2 is oriented so that the normal to the sheet is at an angle of 60 to a uniform electric field of magnitude 14 N>C. (a) Find the magnitude of the electric flux through the sheet. (b) Does the answer to part (a) depend on the shape of the sheet

a. 1.75 Nm²/C

b. Yes.

Explanation:

a. Electric Flux is given as:

Φ = E*A*cosθ

Where E = electric flux

A = Surface area

Φ = 14 * 0.25 * cos60

Φ = 1.75 Nm²/C

b. Yes, the shape of the sheet will affect the Flux through it. This is because flux is dependent on area of the surface and the area is dependent on the shape of the surface.

a and c

explanation:

both a and c are correct answers to my knowledge, it's been a bit since i've done anything related to magnetic fields, but it should be right.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).