subject
Physics, 10.03.2020 23:03 isamar7342

The magnitude J of the current density in a certain wire with a circular cross section of radius R = 2.40 mm is given by J = (3.50 108)r2, with J in amperes per square meter and radial distance r in meters. What is the current through the outer section bounded by r = 0.510R and r = R?

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 02:00
Chapter 23, problem 075 the figure shows a geiger counter, a device used to detect ionizing radiation (radiation that causes ionization of atoms). the counter consists of a thin, positively charged central wire surrounded by a concentric, circular, conducting cylindrical shell with an equal negative charge. thus, a strong radial electric field is set up inside the shell. the shell contains a low-pressure inert gas. a particle of radiation entering the device through the shell wall ionizes a few of the gas atoms. the resulting free electrons (e) are drawn to the positive wire. however, the electric field is so intense that, between collisions with gas atoms, the free electrons gain energy sufficient to ionize these atoms also. more free electrons are thereby created, and the process is repeated until the electrons reach the wire. the resulting "avalanche" of electrons is collected by the wire, generating a signal that is used to record the passage of the original particle of radiation. suppose the radius of the central wire is 24 âµm, the inner radius of the shell 2.3 cm, and the length of the shell 14 cm. if the electric field at the shell's inner wall is 2.8 ă— 104 n/c, what is the total positive charge on the central wire?
Answers: 1
question
Physics, 22.06.2019 02:00
What is created when solids,liquids,an gases mix with one another
Answers: 1
question
Physics, 22.06.2019 08:40
Apulley system is used to lift a 2,000 newton engine up a distance of 3 meters. the operator must apply a force of 250 newtons to the chain of the pulley system to lift the motor. to lift the engine 3 meters, the operator must pull a total of 30 meters of chain through the pulley system. what is the value of di?
Answers: 1
question
Physics, 22.06.2019 10:00
Students design a model roller-coaster track. they place a rubber ball at the highest point on the track and let it go. the ball rolls along the track pulled only by the force of gravity. eventually, it comes to a stop. which change to the design will result in the ball moving the greatest distance?
Answers: 1
You know the right answer?
The magnitude J of the current density in a certain wire with a circular cross section of radius R =...
Questions
question
Chemistry, 26.06.2019 20:10
question
Physics, 26.06.2019 20:10
Questions on the website: 13722359