subject
Physics, 12.03.2020 06:40 ayoismeisjjjjuan

Assume a three-phase, unity power actor load of 100 MVA with VLL of 69 kV is connected to a source through the below network. Convert the two impedances to per unit. Use a per unit three-phase 100 MVA base, a line-to-line 138 kV voltage base on the left side of the transformer and a line-to-line 69 kV voltage base on the right side.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 23:00
Asubmarine has a "crush depth" (that is, the depth at which water pressure will crush the submarine) of 250 m. what is the approximate pressure (water plus atmospheric) at this depth? (recall that the density of seawater is 1025 kg/m3, g = 9.81 m/s2, and 1 kg/(ms2) = 1 pa = 9.8692 10-6 atm.) a. 34.8 atm b. 24.8 atm c. 25.8 atm d. 7.8 atm
Answers: 2
question
Physics, 22.06.2019 11:30
1. a camcorder has a power rating of 19 watts. if the output voltage from its battery is 7 volts, what current does it use?answer units 2. a 1.5m wire carries a 6 a current when a potential difference of 57 v is applied. what is the resistance of the wire? yourunits 3. a clothes dryer uses about 2 amps of current from a 240 volt line. how much power does it use? yourunits 4.
Answers: 1
question
Physics, 22.06.2019 17:50
Which of the following best describes internal energy? a. the difference between the kinetic and potential energies of the particles in a system b. the sum of the kinetic and potential energies of the particles in a system c. the sum of the kinetic and thermal energies of the particles in a system d. the difference between the kinetic and thermal energies of the particles in a system
Answers: 2
question
Physics, 22.06.2019 19:40
Uranium has two naturally occurring isotopes. 238u has a natural abundance of 99.3% and 235u has an abundance of 0.7%. it is the rarer 235u that is needed for nuclear reactors. the isotopes are separated by forming uranium hexafluoride uf6, which is a gas, then allowing it to diffuse through a series of porous membranes. 235uf6 has a slightly larger rms speed than 238uf6 and diffuses slightly faster. many repetitions of this procedure gradually separate the two isotopes. what is the ratio of the rms speed of 235uf6 to that of 238uf6? express your answer to five significant figures.
Answers: 3
You know the right answer?
Assume a three-phase, unity power actor load of 100 MVA with VLL of 69 kV is connected to a source t...
Questions
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
question
Mathematics, 07.05.2021 02:10
Questions on the website: 13722367