Physics, 16.03.2020 23:58 dantew8238

A musician uses a tuning fork of frequency f = 241 Hz to tune his guitar and his trumpet. There is a beat frequency between the tuning fork and the guitar string and between the tuning fork and the trumpet for this note of fbeat = 4 Hz.

a. If the original tension T is 100 N, what must be the new tension T ' in Newtons?
The musician increases the length of an air column in the trumpet and notices that the beat frequency increases.
b. Find the original frequency of this note fT in Hz from the trumpet?

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 03:50

A30 kg weight lies on top of a massless piston of area a = 0.01 m2 the exterior air is at a (constant) p =1 atm and t = 27 c. the interior gas is 0.4 moles of (ideal) n2 and it has initial temperature 27.00 degrees c. 1. what is the initial pressure in the interior? a. 29.4 kpa b. 130.7 kpa c. 101.3 kpa the next three questions concern what happens when an amount of heat q is slowly added to the interior, raising the piston by 1 mm and raising the interior temperature to 27.40 c

Answers: 3

Answer

Physics, 22.06.2019 07:00

World class speed skaters can skate a 3,000-m course in about 4 minutes.what is their average speed for this course? a. 12.5 m/sb. 1.33 m/sc. 1.25 m/sd. 13.3 m/s

Answers: 2

Answer

Physics, 22.06.2019 08:00

What is a carrier wave and how does it affect what you hear on the radio

Answers: 1

Answer

Physics, 22.06.2019 15:30

At 20∘c, the hole in an aluminum ring is 2.800 cm in diameter. you need to slip this ring over a steel shaft that has a room-temperature diameter of 2.804 cm . 1. to what common temperature should the ring and the shaft be heated so that the ring will just fit onto the shaft? coefficients of linear thermal expansion of steel and aluminum are 12×10−6 k−1 and23×10−6 k−1 respectively.

Answers: 1

Answer

You know the right answer?

A musician uses a tuning fork of frequency f = 241 Hz to tune his guitar and his trumpet. There is a...

Questions