An emf is induced by rotating a 1247 turn, 20.0 cm diameter coil in the Earth's 6.13 10-5 T magnetic field. What average emf is induced, given the plane of the coil is originally perpendicular to the Earth's field and is rotated to be parallel to the field in 10.0 ms

The average induced emf = 2.4015V

Explanation:

Given.

Turn, N = 1247

diameter coil = 20cm

Magnetic field = 6.13 * 10^-5T

Parallel to field = 10ms

From Faraday law, we know that the emf induced in a coil is directly proportional to the rate of change of magnetic flux through the coil.

This is given by;

-Nd∅b/ft

= -N * d/dt(BA)

= -NB*dA/dt

= - 1247 * 6.13 * 10^-5 * (0 - (π * 0.10²))/0.001

= 2.40146798192322743920646

= 2.4015V Approximated

The average induced emf = 2.4015V

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

i need the answer to this too but idk it ; -;