Physics, 30.03.2020 15:32 Cheyenne7327

You are camping in the wilderness. After a few days, you are horrified to discover that you did not pack as many batteries as you had planned, and you have no working batteries for your lights at night. Rummaging through the spare parts in the back of your truck, you find an old motor. On the plate, the information claims that the motor operates from 120 V, rotating at 1,600 rev/min, with an average back emf of 80.0 V. You wish to use the motor as a generator to provide a voltage with a peak value of 7.50 V to operate your electric lantern. You attach a hand crank to the armature of the motor. You need to determine the angular speed (in rev/s) at which you must rotate the crank to provide the desired voltage. Model the armature as a flat coil of wire. Notice that the average back emf is provided, not the peak value, so you will need to find an expression for the average back emf of a motor in terms of parameters associated with the armature rev/s Need Help?

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 08:30

Researchers determine that the biodiversity in a woodland region is declining. they identify two major threats to the region's biodiversity, a method to address each threat, and the expected outcome of each method. this information is shown in the table. a) reforestation would not benefit many species because most forest species live on the ground. b) reforestation would take the longest time to be effective because trees take several years to grow. c) biological augmentation would benefit only a few species because is is typically not very effective. d) biological augmentation would take less time to ve effective because it targets the majority of prey species.

Answers: 3

Answer

Physics, 22.06.2019 15:20

Acarpenter builds an exterior house wall with a layer of wood 2.9 cm thick on the outside and a layer of styrofoam insulation 2.3 cm thick on the inside wall surface. the wood has k=0.080w/(m⋅k), and the styrofoam has k= 0.010 w/(m⋅k). the interior surface temperature is 19.0 ∘c , and the exterior surface temperature is -15.0 ∘c . a.)what is the temperature at the plane where the wood meets the styrofoam? celsius b.)what is the rate of heat flow per square meter through this wall? /m^2

Answers: 2

Answer

Physics, 22.06.2019 18:10

Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)

Answers: 1

Answer

Physics, 22.06.2019 18:30

Daughter element the new element produced along with a decay particle in a nuclear transmutation 2. half-life the substance that decays in a nuclear transmutation 3. parent element the change of one chemical element into another by nuclear decay or radioactive bombardment 4. transmutation the time required for the decay of one-half of the atoms in a sample of radioactive material

Answers: 2

Answer

You know the right answer?

You are camping in the wilderness. After a few days, you are horrified to discover that you did not...

Questions

Engineering, 06.12.2021 01:40

2. A foundry ships engine blocks in lots of 20. Three items are selected and tested. If the lot actually contains five defective items. find the proba...