Physics, 30.03.2020 23:23 jaici68

Which wave, A or B, has higher energy?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 23:00

The key to stability is feedback between the reservoir and the fluxes into and/or out of the reservoir. assume that the rate of outflow from a reservoir depends on the size of the reservoir according to the following relationship: outflow rate= k x (size of reservoir), where k is a constant. a reservoir of water has a volume of 5000 liters, and the rate of outflow at steady state is 25 liters per minute. what is k? (give both the numerical value and its units.) what is the residence time? what is the relationship between k and the residence time?

Answers: 1

Answer

Physics, 22.06.2019 11:30

Balloon a has charge q, and identical mass balloon b has charge 10q. you hang them from threads near each other. choose all of the statements with which you agree. check all that apply. a. a and b exert the same magnitude forces on each other. b. the force that a exerts on b is 10 times the force that b exerts on a. c. the angle between the thread supporting a and the vertical is < the angle between the thread supporting b and the vertical. d. the force that a exerts on b is 1/10 the force that b exerts on a.

Answers: 2

Answer

Physics, 22.06.2019 14:20

A1-lb collar is attached to a spring and slides without friction along a circular rod in a vertical plane. the spring has an undeformed length of 5 in. and a constant k =25 lb/ft. knowing that the collar is released from being held at a determine, the speed of the collar and the normal force between the collar and the rod as the collar passes through b.

Answers: 3

Answer

Physics, 22.06.2019 18:00

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)