Physics, 31.03.2020 01:50 fatlenny

1. Household circuits are often wired with two different widths of wires: 12-gauge and 14-gauge. The 12-gauge wire has a diameter of 1/12 inch while the 14-gauge wire has a diameter of 1/14 inch. Thus, 12-gauge wire has a wider cross section than 14-gauge wire. A 20-Amp circuit used for wall receptacles should be wired using 12-gauge wire and a 15-Amp circuit used for lighting and fan circuits should be wired using 14-gauge wire. Explain the physics behind such an electrical code.

Answers: 1

Show answers

Answers

Answer from: wow65

This formula R =ρL/A

Where R = resistance of wire, ρ = resistivity of the wire and A = area of the wire. Shows there is an inverse relationship between Resistance and Area of the wire.

Explanation:

A simple way to explain the physics behind such an electrical code is to compare the flow of current through wires to the flow of water through pipes, they are similar in any respect. The resistance to the flow of current in an electric circuit is similar to the frictional experienced by water when flowing through water pipes. Just as water will flow easily with little resistance through a water pipe with the larger cross-sectional area than one with a smaller cross-sectional area, in the same way, wires with larger cross-sectional area will allow the flow of larger amount of current compared to wires with smaller cross-sectional area assuming all other variables are the same.

From the formula R =ρL/A

Where R = resistance of wire, ρ = resistivity of the wire and A = area of the wire

We can see that the resistance and area of the wire have an inverse relationship. An increase in the area of the wire will lead to a decrease in the resistance of the wire.

Answer from: ndndndjdjdjdn

It can be said that a 12 gauge wire is wider than a 14 gauge wire, this means that it will have less resistance. This means that it allows the electric charge to flow at a much higher speed, allowing for a higher current.

Explanation:

As a conclusion, the 12 gauge wire is used in circuits that find 20A fuse protection. However, the 14 gauge wire can withstand less electrical current because it has a higher resistance. These 14 gauge cables are used in circuits that meet 15A fuse protection.

Answer from: Quest

Ithink the answer is d i hope it my friend message me if i’m wrong and i’ll change my answer and fix it for you

Answer from: Quest

-4 on

Another question on Physics

Physics, 21.06.2019 23:30

Classify the following soils according to the uscs classification system. provide appropriate uscs designations. a) this sample of well-graded gravel with sand was obtained from a large earthen dam in vancouver, canada. the sample has 73% fine to coarse sub-angular gravel, 25% fine to coarse sub-angular sand and 2% fines. the maximum size of the particles is 75 mm. the coefficient of curvature is 2.7, while the uniformity coefficient is 12.4. b) this dark brown and wet soil with a â€śstrong organic odorâ€ť has 100% passing the no. 200 sieve. the liquid limit of the material is 32% when not dried and is 21% when oven-dried. the plastic index is 21% when not dried. c) this sand has 61% predominantly fine sand, 23% silty fines, and 16% fine sub-rounded gravel size. the maximum size is 20 mm. the liquid limit is 33% and the plastic limit is 27%. d) this soil has 74% fine to coarse sub-angular reddish sand and 26% organic and silty dark brown fines. the liquid limit is 37% when not dried and is 26% when oven dried. the plastic index is 6% when not dried.

Answers: 1

Answer

Physics, 22.06.2019 04:00

Amodel rocket with a mass of 0.212 kg is launched into the air with an initial speed of 84 m/s. how much kinetic energy will the rocket have at a height of 214 m? assume there is no wind resistance. 634 j 303 j

Answers: 2

Answer

Physics, 22.06.2019 11:30

Where is the potential energy throughout the loading, cocking, and releasing of the trebuchet?

Answers: 2

Answer

Physics, 22.06.2019 18:30

Ablock of mass m slides on a horizontal frictionless table with an initial speed v0 . it then compresses a spring of force constant k and is brought to rest. the acceleration of gravity is 9.8 m/s2. how much is the spring compressed x from its natural length? 1) x = v0*sqrt(k/(mg)) 2) x=v0*sqrt(m/k) 3) x=v0*((mk)/g) 4) x=v0*sqrt(k/m) 5) x=v0*(m/kg) 6) x=v0*sqrt((mg)/k) 7) x=(v0)^2/(2g) 8) x=v0*(k/(mg)) 9) x=(v0)^2/(2m) 10) x=v0*((mg)/k)

Answers: 3

Answer

You know the right answer?

1. Household circuits are often wired with two different widths of wires: 12-gauge and 14-gauge. The...

Questions