Physics, 04.04.2020 06:21 cherylmorton7302

Consider the 20×60mm (h×b) bar with a 10-mm diameter hole which is made of steel with equal tensile and compressive yield strengths of 600 MPa. If we assume the material behaves with an ideal elastic-plastic stress strain response and the plate is initiallyfree of residual stresses, make a drawing of the stress distribution in the plane of the hole:a) When a tensile load of 200 kN is applied. b) When a tensile load of 400 kN is applied. c) After the 400 kN load is removed. d) What compressive load would you need to apply to make the material yield in compression?

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 00:50

While goofing off at the ice skating rink, a student takes off her shoes and places each of them on the ice. her friend, a hockey player, then shoots a hockey puck at each shoe. the first puck immediately comes to rest after it collides with the left shoe. the second puck rebounds after it collides with the right shoe. if each hockey puck has the same incoming speed, which shoe has greater speed after the collision? the right shoe. both shoes have the same speed. the left shoe.

Answers: 3

Answer

Physics, 22.06.2019 08:00

If the force applied to an object remains constant, is more power needed for the object to move faster ? explain

Answers: 3

Answer

Physics, 22.06.2019 14:00

Estimate the change in the gibbs energy and molar gibbs energy of 1.0dm3 of octane when the pressure acting on it is increased from 1.0 atm to 100 atm. the mass density of octane is 0.703 g cm−3

Answers: 3

Answer

Physics, 22.06.2019 19:30

Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?

Answers: 3

Answer

You know the right answer?

Consider the 20×60mm (h×b) bar with a 10-mm diameter hole which is made of steel with equal tensile...

Questions