6–31. A uniform live load of 16 kN>m and a single concentrated live force of 34 kN are placed on the top beams. If the beams also support a uniform dead load of 3 kN>m, determine (a) the maximum positive shear in panel BC of the girder and (b) the maximum positive moment in the girder at C. Assume B is a roller and D is a pin.

What tightening torque should be used for a hexagonal head screw (not split-bolt) on a 250 kcmil conductor?

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?

An athlete is holding 24 lb of weights at a height of 6 inches above the stack as shown. to lower the weights, she applies a constant force of 5 lb to the handle. determine the velocity of the weights immediately before they hit the stack.