subject
Physics, 20.04.2020 22:12 lazarovalle3598

A source of emf is connected by wires to a resistor, and electrons flow in the circuit. The wire diameter is the same throughout the circuit. Compared to the drift speed of the electrons before entering the source of emf, the drift speed of the electrons after leaving the source of emf is .A. faster. B. slower. C. the same. D. either A or B depending on circumstances. E. any of A, B, or C depending on circumstances.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 18:10
The difference between two numbers is 15. when twice the smaller number is subtracted from three times the larger number, the difference is 58.what is the larger number?
Answers: 1
question
Physics, 22.06.2019 10:30
Agroup of students were investigating the force of gravity. they began by dropping a foam ball from a height of 3 meters into a bucket of sand. the ball hit the sand in 0.306 seconds. they dropped additional balls of approximately the same diameter, but of different masses. here is the data they collected. based on this experiment and the collected data, what would their conclusion be?
Answers: 1
question
Physics, 22.06.2019 15:00
Astudent throws a water balloon with speed v0 from a height h = 1.76 m at an angle θ = 21° above the horizontal toward a target on the ground. the target is located a horizontal distance d = 9.5 m from the student’s feet. assume that the balloon moves without air resistance. use a cartesian coordinate system with the origin at the balloon's initial position. (a) what is the position vector, rtarge t, that originates from the balloon's original position and terminates at the target? put this in terms of h and d, and represent it as a vector using i and j. (b) in terms of the variables in the problem, determine the time, t, after the launch it takes the balloon to reach the target. your answer should not include h. (c) create an expression for the balloon's vertical position as a function of time, y(t), in terms of t, vo, g, and θ. (d) determine the magnitude of the balloon's initial velocity, v0, in meters per second, by eliminating t from the previous two expressions.
Answers: 3
question
Physics, 22.06.2019 18:10
Arefrigerator uses r-134a as the working fluid and operates on the ideal vapor-compression refrigeration cycle except for the compression process. the refrigerant enters the evaporator at 120 kpa with a quality of 34 percent and leaves the compressor at 70°c. if the compressor consumes 450 w of power, determine (a) the mass flow rate of the refrigerant, (b) the condenser pressure, and (c) the cop of the refrigerator. (0.00644 kg/s, 800 kpa, 2.03)
Answers: 1
You know the right answer?
A source of emf is connected by wires to a resistor, and electrons flow in the circuit. The wire dia...
Questions
question
Computers and Technology, 19.09.2020 01:01
Questions on the website: 13722359