Machine A and Machine B performed the same amount of work, but Machine A did it in less time. What can be concluded?

A. Machine A used more energy.
B. Machine A and Machine B have the same power output.
C. Machine A has the higher power output.
D. Machine B has the higher power output.

To run the physics cart, the fan speed of the cart is manipulated. this is the (blank) variable. the cart accelerates due to the speed of the fan. acceleration is therefore the (blank) variable. a “constant” is a parameter that stays the same regardless of the variables. one parameter of the cart that is held constant is the (blank) .

(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.

Steam is generated in a boiler of a cogeneration plant at 10 mpa and 450°c at a steady rate of 5 kg/s. in normal operation, steam expands in a turbine to a pressure of 0.5 mpa and is then routed to the process heater, where it supplies the process heat. steam leaves the process heater as a saturated liquid and is pumped to the boiler pressure. in this mode, no steam passes through a condenser, which operates at 20 kpa. (a) determine the power produced in the turbine and the rate at which process heat is supplied in this mode. (b) determine the power produced in the turbine and the rate of process heat supplied if only 60 percent of the steam is routed to the process heater and the remainder is expanded to the condenser pressure. (3.32 mw; 9.69 mw; 4.25 mw; 5.82 mw)