A loop of wire is at the edge of a region of space containing a uniform magnetic field B⃗ . The plane of the loop is perpendicular to the magnetic field. Now the loop is pulled out of this region in such a way that the area A of the coil inside the magnetic field region is decreasing at the constant rate c. That is, dAdt=−c, with c>0.Part A

The induced emf in the loop is measuredto be V. What is the magnitude B of the magnetic field that the loop was in?

Part B

For the case of a square loop of sidelength L being pulled out of the magneticfield with constant speed v, what is the rate of change ofarea c = -\frac{da}{dt}?

The question is not clear enough. So i have attached a copy of the correct question.

A) B = V/c

B) c = Lv

Explanation:

A) we know that formula for magnetic flux is;

Φ = BA

Where B is magnetic field and A is area

Now,

Let's differentiate with B being a constant;

dΦ/dt = B•dA/dt

From faradays law, the EMF induced is given as;

E = -dΦ/dt

However, we want to express it in terms of V and E.M.F is also known as potential difference or Voltage.

Thus, V = -dΦ/dt

Thus, we can now say that;

-V = B•dA/dt

Now from the question, we are told that dA/dt = - c

Thus;

-V = B•-c

So, V = Bc

Thus, B = V/c

B) according to Faraday's Law or Lorentz Force Law, an electromotive force, emf, will be induced between the two ends of the sidelength:

Thus;

E =LvB or can be written as; V = LvB

Where;

V is EMF

L is length of bar

v is velocity

From the first solution, we saw that;

V = Bc

Thus, equating both of the equations, we have;

Bc = LvB

B will cancel out to give;

c = Lv

as a general rule, scissors have blades less than 6 in (15 cm) long and usually have handles with finger holes of the same size. shears have blades scissors used to cut hair or fabric must be much sharper.

. west