subject
Physics, 05.05.2020 07:21 jacobd578

In order to heat a large block of iron, you place a smaller, hot block of iron next to it. Initially, the large block of Fe is at room temperature (295 K) and the small block of Fe is at 700 K. Assume that the system (both blocks) is in thermal isolation from the surroundings. As you have seen, the entropy of a system is a function of the number of ways there is to arrange all of the energy in that system.
Consider the following situations:
i) All of the thermal energy is found in the large Fe block.
ii) All of the thermal energy is found in the small Fe block.
iii) There is an equal amount of thermal energy in the large Fe block as there is in the small Fe block.
iv) The average energy per Fe atom in the large block is equal to the average energy per Fe atom in the small block.
Determine:
(a) Which situation is associated with the largest number of ways to arrange the total energy in the system? Which is associated with the fewest number of ways to arrange the energy? Are any of these situations associated with the same number of ways to arrange the energy?
(b) Would any of the above situations be a violation of the Energy Principle? Why or why not?
(c) If you leave the two blocks in contact until the system reaches thermal equilibrium, what can be said about the system?

a) The final temperature of the large iron block is less than the final temperature of the small iron block.
b) The entropy of the total system has increased.
c) The entropy of just the small iron block has remained the same.
d) The total energy of the system has decreased.
e) All of the above.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 23:30
Truck traveling west on the highway experiences an acceleration to the east. what could be the cause of this acceleration
Answers: 1
question
Physics, 21.06.2019 23:30
Aknife blade is a(n) a. lever b. screw c. wedge d. inclined plane
Answers: 2
question
Physics, 22.06.2019 02:30
Agas initially at p1 = 1 bar and occupying a volume of 0.5 liter is compressed within a piston–cylinder assembly to a final pressure p2 = 4 bar. (a) if the relationship between pressure and volume during the compression is pv = constant, determine the volume, in liters, at a pressure of 3 bar. (b) repeat for a linear pressure–volume relationship between the same end states. reference
Answers: 1
question
Physics, 22.06.2019 12:00
If the new moon happens on january 15th, what shape will it be on february 6th?
Answers: 1
You know the right answer?
In order to heat a large block of iron, you place a smaller, hot block of iron next to it. Initially...
Questions
question
Social Studies, 22.06.2019 01:30
question
Social Studies, 22.06.2019 01:30
Questions on the website: 13722360