subject
Physics, 03.06.2020 03:58 FatCatcreator

To understand the experiment that led to the discovery of the photoelectric effect.
In 1887, Heinrich Hertz investigated the phenomenon of light striking a metal surface, causing the ejection of electrons from the metal. The classical theory of electromagnetism predicted that the energy of the electrons ejected should have been proportional to the intensity of the light. However, Hertz observed that the energy of the electrons was independent of the intensity of the light. Furthermore, for low enough frequencies, no electrons were ejected, no matter how great the intensity of the light became. The following problem outlines the methods used to investigate this new finding in physics: the photoelectric effect.
Suppose there is a potential difference between the metal that ejects the electrons and the detection device, such that the detector is at a lower potential than the metal. The electrons slow down as they go from higher to lower electric potential; since they must overcome this potential difference to reach the detector, this potential is known as the stopping potential. To reach the detector, the initial kinetic energy of an ejected electron must be greater than or equal to the amount of energy it will lose by moving through the potential difference.
(A) If there is a potential difference V between the metal and the detector, what is the minimum energy E_min that an electron must have so that it will reach the detector?
Express your answer in terms of V and the magnitude of the charge on the electron, e.
(B) Suppose that the light carries energy E_light. What is the maximum stopping potential V_0 that can be applied while still allowing electrons to reach the detector?
Express your answer in terms e, E_light, and Φ.

ansver
Answers: 1

Another question on Physics

question
Physics, 21.06.2019 23:30
Adding more pulleys to a system of pulleys needed to lift an object. a. increases the force b. decreases the force c. increases the amount of work d. decreases the amount of work
Answers: 1
question
Physics, 22.06.2019 06:00
Why don't you see your reflection in water with waves or repples
Answers: 1
question
Physics, 22.06.2019 08:00
Gather reliable information to brent make his decision. to gather this information, use newspapers, call insurance companies or look at their web sites, and review consumer magazines and web sites. also, look at the manufacturer web site or for information about gas mileage. list the sources you use and take notes.
Answers: 1
question
Physics, 22.06.2019 11:00
1. jay fills a wagon with sand (about 20 kg) and pulls it with a rope 30 m along the beach. he holds the rope 25° above the horizontal. the rope exerts a 20-n tension force on the wagon. how much work does the rope do on the wagon?
Answers: 1
You know the right answer?
To understand the experiment that led to the discovery of the photoelectric effect.
In 1887, H...
Questions
Questions on the website: 13722360