subject
Physics, 05.06.2020 01:02 Jennifer16253

The resistivity of a metal increases slightly with increased temperature. This can be expressed as rho=rho0[1+α(T−T0)], where T0 is a reference temperature, usually 20∘C, and α is the temperature coefficient of resistivity. Part A First find an expression for the current I through a wire of length L, cross-section area A, and temperature T when connected across the terminals of an ideal battery with terminal voltage ΔV. Then, because the change in resistance is small, use the binomial approximation to simplify your expression. Your final expression should have the temperature coefficient α in the numerator. Express your answer in terms of L, A, T, T0, ΔV, rho0, and α.

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 18:00
This question is worth 54 points ! rock falls from a ledge to the ground what energy conversion occurs during this process a potential to kinetic b kinetic to potential c thermal to mechanical d chemical to mechanical
Answers: 2
question
Physics, 22.06.2019 18:00
By what factor does the drag force on a car increase as it goes from 65 to 110 km/h?
Answers: 1
question
Physics, 22.06.2019 21:30
The diagram shows a boulder rolling down a hill into a valley and then up the opposite hill. at which position does the boulder have the greatest kinetic energy? a b c d
Answers: 2
question
Physics, 22.06.2019 23:00
Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.
Answers: 2
You know the right answer?
The resistivity of a metal increases slightly with increased temperature. This can be expressed as r...
Questions
question
Biology, 23.03.2021 15:30
question
Physics, 23.03.2021 15:30
question
Computers and Technology, 23.03.2021 15:30
question
Mathematics, 23.03.2021 15:30
question
Biology, 23.03.2021 15:30
Questions on the website: 13722367