subject
Physics, 20.06.2020 01:57 RandomLollipop

Your spaceship lands on an unknown planet. To determine the characteristics of this planet, you drop a wrench from 5.00 m above the ground and measure that it hits the ground 0.804 s later. Part APart complete What is the acceleration of gravity near the surface of this planet

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 00:50
Acave rescue team lifts an injured spelunker directly upward and out of a sinkhole by means of a motor-driven cable. the lift is performed in three stages, each requiring a vertical distance of 10.0 m: (a) the initially stationary spelunker is accelerated to a speed of 4.90 m/s; (b) he is then lifted at the constant speed of 4.90 m/s; (c) finally he is decelerated to zero speed. how much work is done on the 68.0 kg rescue by the force lifting him during each stage?
Answers: 1
question
Physics, 22.06.2019 12:10
The average density of the planet uranus is 1.27 103 kg/m3. the ratio of the mass of neptune to that of uranus is 1.19. the ratio of the radius of neptune to that of uranus is 0.969. find the average density of neptune.
Answers: 1
question
Physics, 22.06.2019 15:30
Ametal ring 4.20 cm in diameter is placed between the north and south poles of large magnets with the plane of its area perpendicular to the magnetic field. these magnets produce an initial uniform field of 1.12 t between them but are gradually pulled apart, causing this field to remain uniform but decrease steadily at 0.240 t/s . (a) what is the magnitude of the electric field induced in the ring? (b) in which direction (clockwise or counterclockwise) does the current flow as viewed by someone on the south pole of the magnet?
Answers: 2
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
You know the right answer?
Your spaceship lands on an unknown planet. To determine the characteristics of this planet, you drop...
Questions
question
Chemistry, 13.03.2020 22:57
Questions on the website: 13722361