Physics, 02.07.2020 20:01 paiged55

Three resistors of 4.0, 6.0, and 10.0 Ω are connected in parallel. If the combination is connected in series with a 12.0-V battery and a 2.0-Ω resistor, what is the current through the 10.0-Ω resistor? Group of answer choices

Answers: 2

Show answers

Another question on Physics

Physics, 22.06.2019 12:20

Aball with a mass of 275 g is dropped from rest, hits the floor and rebounds upward. if the ball hits the floor with a speed of 2.40 m/s and rebounds with a speed of 1.70 m/s, determine the following. (a) magnitude of the change in the ball's momentum (let up be in the positive direction.)

Answers: 1

Answer

Physics, 22.06.2019 17:30

You can watch static electricity in action by rubbing an inflated balloon against your hair. your hair will actually stand on its end! it does this because each hair becomes charged, and they all repel one another.

Answers: 3

Answer

Physics, 22.06.2019 20:40

Aloop of wire is in a magnetic field such that its axis is parallel with the field direction. which of the following would result in an induced emf in the loop? choose all that apply. a loop of wire is in a magnetic field such that its axis is parallel with the field direction. which of the following would result in an induced emf in the loop? choose all that apply. moving the loop outside of the magnetic field region. spin the loop such that its axis does not consistently line up with the magnetic field direction. change the magnitude of the magnetic field. change the diameter of the loop

Answers: 1

Answer

Physics, 22.06.2019 23:00

Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.

Answers: 2

Answer

You know the right answer?

Three resistors of 4.0, 6.0, and 10.0 Ω are connected in parallel. If the combination is connected i...

Questions