A hollow steel shaft is to transmit 4200 n. m of torque and is to be sized so that the torsional stress does not exceed 120 mpa

A hollow steel shaft is to transmit 4200 n.m of torque and is to be sized so that the torsional stress does not exceed 120 Mpa

If the inside diameter is 70 percent of the outside diameter, what size shaft should be used?

the preferred outer diameter  of the hollow steel shaft obtained a little bit higher than 61.67 mm is 80 mm

the preferred inner diameter of the hollow steel obtained a little bit lower than 56 mm is 50 mm

Explanation:

From above;

let the inside diameter be

let the outside diameter be

Then

= 70%  

  ------ (1)

to determine the outer diameter of the hollow steel shaft by using the equation of the torque, we have:

where;

= torsoinal shear stress = 120 MPa

From the tables of A-17 of sized and Renard Numbers,

the preferred outer diameter  of the hollow steel shaft obtained a little bit higher than 61.67 mm is 80 mm

However, from equation (1)

  ------ (1)

replacing the value of

From the tables of A-17 of sized and Renard Numbers,

the preferred inner diameter of the hollow steel obtained a little bit lower than 56 mm is 50 mm

a

explanation:

no diagram was provided, but i'm guessing it's the one i've attached to my answer.

here, a mechanical force turns the rod.   this generates an electric current in the coil, which powers the bulb.

answergravity;