If the diameter of the black marble is 3.0 cm, and by using the formula for volume, what is a good approximation of its volume? Record to the ones place. cm3 Determine the initial volume of water in the graduated cylinder. If you added the black marble to the graduated cylinder and it sinks, what final volume should the water level indicate? Record to the ones place. mL

The inside surface of a cylindrical-shaped cave of inner diameter 1.0 m is continuously covered with a very thin layer of water. the cave is very long and it is open on both ends. the water on the cave surface is at a constant temperature of 15.5 °c. the cave is constantly exposed to wind such that 15.5 °c air flows through the cave at 4.5 m/s. the kinematic viscosity of the air is 14.66 x 10-6 m2/s and the molecular diffusion coefficient of water vapor in the air is 0.239 x 10-4 m2/s. because the cave diameter is so large, the flow of wind down the length of the cave, in the x direction, can be treated like it is external flow and the cave surface can be approximated as flat where appropriate. calculate the x value, in a) the transition to turbulent flow occurs at rex meters, where the air flow transitions from laminar to turbulent along the inside surface of the cave b) calculate the x value, in meters, where the bulk steady state concentration of water vapor in the air flowing in the cave is 10% of the saturation concentration. assume the air at the surface of the water layer is 100% saturated with water vapor. assume the wind entering the cave contained no moisture before it entered the cave. take into account the transition from laminar to turbulent flow when solving part b

Six pendulums of mass mand length las shown are released from rest at the same angle theta from vertical. rank the pendulums according to the numberof complete cycles of motion each pendulum goes through perminute. a. l= 1m m=2kg b. l= 4m m=1 kg c. l= 2 m m= 2 kg d. l= 1 m m= 4 kg e. l= 2 m m = 4 kg f. l= 4m m = 4kg

Dc versus ac problem. suppose your dc power supply is set to 15 v and the vertical setting on the oscilloscope is at 5 v/div. how many divisions will the trace deflect if you connect the output of the power supply to the scope with the a input switch set on dc? how many divisions if the switch is on ac?