An investigation has been completed similar to the one on latent heat of fusion, where steam is bubbled through a container of water. Steam condenses and the lost energy heats the water and container. Use the following data to answer the question below: Mass of the aluminum container 50 g
Mass of the container and water 250 g
Mass of the water 200 g
Initial temperature of the container and water 20°C
Temperature of the steam 100°C
Final temperature of the container, water, and condensed steam 50°C
Mass of the container, water, and condensed steam 261 g
Mass of the steam 11 g
Specific heat of aluminum 0.22 cal/g°C
Given the data above, determine the total heat energy gained by the container and water.

2900 cal
6300 cal
6500 cal
7800 cal

  the grams     of oxygen gas   that can be produced     is 20.6   grams of o₂

calculation

2liclo₃ →   2 licl + 3 o₂

step 1:   find the moles of liclo₃

moles = mass÷ molar mass

from periodic table the molar mass of liclo₃ =6.9 +35.5   +(16 x3) =90.4 g/mol

moles=38.7 g÷90.4 g/mol=0.4281   moles

step 2:   use the   mole ratio   to calculate the moles of o2

from equation above, liclo₃: o₂   is 2: 3  

therefore the moles of   o₂=0.4281 moles x3/2 =0.6422   moles

step 3: find mass   of o₂

mass= moles x molar mass

from periodic table the   molar mass of   o₂ = 16 x2= 32 g/mol

mass=0.6422   moles   x   32 g/mol = 20.6 grams of o₂

1/0.14nm = 10^10/1.4 a lot

the box does not move because you need to use a force greater than 300 n. you are only using 50 n. it needs to at least be 301 n for the box to move because then it is an unbalanced force and it will move the way that the greater force is pushing it. if you use only 300 n it will be a balanced force and will not move because the force you are exerting on the   box is the same as its force.

hope this !

im sorry if i went too in depth, i am going to include a link to a video on khan academy that will explain this.   hope that you like the video and that it explains more in detail to you.

that is the link.

the answer is f1 and d2 because if you put equal force on those two points the beam would balance trust me on this