subject
Physics, 27.10.2020 08:20 jholland03

Jim is pulling a load along a ramp, as shown. The diagram shows the force with which he pulls and the weight of the load. a. Calculate the work done by Jim’s pulling force?

b. What is the gain in potential energy of the load?

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 18:20
Which is not a step in the rock cycle?
Answers: 1
question
Physics, 22.06.2019 04:00
Which configuration would produce an electric current? a) rotate a coil of copper wire between two magnets. b) connect a wire between a copper and zinc strip sitting in a beaker of water. c) connect a wire to the (+) positive end of a battery and the other end to a light bulb. d) connect a wire to the negative end of a battery and the other end to a light bulb.
Answers: 2
question
Physics, 22.06.2019 05:10
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
question
Physics, 22.06.2019 09:30
The graph represents the distance a car travels over time while on the highway. which statement about the car's trip is accurate? a) the car does not move over time. b) the car travels at a constant velocity. c) the car's velocity increases constantly over time. d) the car's velocity decreases constantly over time.
Answers: 1
You know the right answer?
Jim is pulling a load along a ramp, as shown. The diagram shows the force with which he pulls and th...
Questions
Questions on the website: 13722360