Physics, 03.11.2020 21:00 stevenabramyan

After a day of testing race cars, you decide to take your own 1516.4 kg car onto the test track. While moving down the track ar 13.4 m/s. Vou suddenly accelerate to 26. 4 m/ What average net force have you applied to the car during that time?

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 22:40

Ablock of mass m = 2.5 kg is attached to a spring with spring constant k = 710 n/m. it is initially at rest on an inclined plane that is at an angle of θ = 23° with respect to the horizontal, and the coefficient of kinetic friction between the block and the plane is μk = 0.19. in the initial position, where the spring is compressed by a distance of d = 0.16 m, the mass is at its lowest position and the spring is compressed the maximum amount. take the initial gravitational energy of the block as zero. a) what is the block's initial mechanical energy? b) if the spring pushes the block up the incline, what distance, l, in meters will the block travel before coming to rest? the spring remains attached to both the block and the fixed wall throughout its motion.

Answers: 3

Answer

Physics, 22.06.2019 09:00

A2000 kg car is rounding a curve of radius 200 m on a level road. the maximum frictional force the road can exert on the tires of the car is 4000 n. what is the highest speed at which the car can round the curve?

Answers: 1

Answer

Physics, 23.06.2019 05:10

Which of the following should not be included in a great summary? a. blaming your lab partner b. new questions your experiment has generated c. your prediction d. your investigation plan

Answers: 2

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

After a day of testing race cars, you decide to take your own 1516.4 kg car onto the test track. Whi...

Questions