Physics, 25.08.2019 17:10 jonnydean0817

How to find the coefficient of kinetic friction?

Answers: 1

Show answers

Answers

Learn and understand the equation used to find the coefficient of friction. The magnitude of the force of kinetic friction is f(k) = u(k)N, where N is the normal force. The coefficient therefore is f(k)/N. It is a dimensionless number, and its value depends upon the surface. Smooth surfaces have lower values than rougher ones. For example, for a glass-upon-glass surface, it may be 0.6, and for ice-on-ice it may be 0.03. These numbers are approximate depending on whether the surfaces are clean, wet or sanded, for example.2 Use the equation given in Step 1 to find the coefficient if you have a problem where you are given f(k) and N. Plug in the values and solve directly for u(k). If you are not given the frictional and normal forces, proceed to Step 33.Calculate f(k) and N by using Newton's second law F = ma. Find the sum of all of the forces acting upon the moving object. Remember that for no acceleration, the net forces will be equal to zero. Remember also that f(k) opposes movement, and so will be opposite in sign to the force making the object move.4 Draw a free body diagram to find the horizontal and vertical components of the forces acting upon the object in Step 3. A standard example is a box being pulled by a rope or a person pulling another person on a sled.Practice Steps 3 and 4 by studying the diagram to the left, and writing out the appropriate equations. Shown is a pulling force, F, along with a frictional force, f(k), a normal force, N, and a gravitational force, mg. There is no acceleration.The sum of all the forces: F + N + f(k) + mg = 0.
The sum of all the horizontal forces: Fh -- f(k) = 0 (there is no acceleration).
The sum of all of the vertical forces: Fv + N -- mg = 0 (the object is not moving up or down).
Use f = u(k)N, Fv = Fsin(theta), and Fh = Fcos(theta) to solve the second and third equations simultaneously to find the coefficient of friction u(k). The answer is u(k) = Fcos(theta) / (mg -- Fsin(theta)).

Answer from: Quest

The center is basically the heart of it

Answer from: Quest

r = ρ x length / area

ρ = r x area / length

ρ is in ohm-meters

in basic units, it is m³kg/s³a²

i think this is it.

Another question on Physics

Physics, 21.06.2019 19:10

Athin, square metal plate measures 14 cm on each side and has emissivity of 0.60. the plate is heated to a temperature of 745°c. what is the rate at which the plate radiates energy ? the stefan-boltzmann constant is 5.67 × 10-8 w/(m2 ? k4). remember that the plate will radiate energy from both its top and bottom surfaces.

Answers: 1

Answer

Physics, 22.06.2019 14:00

Amass attached to a spring is displaced from its equilibrium position by 5cm and released. the system then oscillates in simple harmonic motion with a period of 1s. if that same mass–spring system is displaced from equilibrium by 10cm instead, what will its period be in this case? a mass attached to a spring is displaced from its equilibrium position by and released. the system then oscillates in simple harmonic motion with a period of . if that same mass–spring system is displaced from equilibrium by instead, what will its period be in this case? a) 0.5sb) 2sc) 1sd) 1.4s

Answers: 2

Answer

Physics, 22.06.2019 23:00

As seen in a us weather map, the h (or high) and l (or low) symbols indicate regions where surface air pressures are high or low, respectively, compared to surrounding areas. an h is plotted where the air pressure is highest and an l is plotted where the air pressure is lowest. proceeding outward and away from the center of a high pressure system, the air pressure "

Answers: 1

Answer

Physics, 23.06.2019 18:00

Radioisotopes often emit alpha particles, beta particles, or gamma rays. the distance they travel through matter increases in order from alpha to gamma. each radioisotope has a characteristic half-life, which is the time needed for half of a sample of radioisotope to undergo nuclear decay. which quality is desirable for a radioisotope that is used for medical imaging of a specific organ? check all that apply. half-life of several years half-life of several days half-life of several seconds emission of gamma rays emission of alpha particles ability to be attached to a compound used by the body ability to pass through the body without being absorbed