subject
Physics, 08.11.2020 03:10 itsshyraa

Give me an answer and show work please thank you


Give me an answer and show work please thank you

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 04:40
Argon is adiabatically compressed from an initial volume of 16 liters to a final volume of 2 liters. by what factor do the following quantities change? do they increase or decrease? (a) the rms speed (b) the thermal energy of the gas (c) the molar specific heat cv (d) the pressure
Answers: 3
question
Physics, 22.06.2019 19:00
The friction of the water on a boat produces an acceleration of -10. m/s2. if the boat is traveling at 30. m/s and the motor is shut off, how long it take the boat to slow down to 5.0 m/s?
Answers: 3
question
Physics, 23.06.2019 01:30
The flame produced by the burner of a gas (propane) grill is a pale blue color when enough air mixes with the propane (c3h8) to burn it completely. for every gram of propane that flows through the burner, what volume of air is needed to burn it completely? assume that the temperature of the burner is 195.0°c, the pressure is 1.05 atm, and the mole fraction of o2 in air is 0.210.
Answers: 2
question
Physics, 23.06.2019 02:10
Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.
Answers: 1
You know the right answer?
Give me an answer and show work please thank you
...
Questions
question
Mathematics, 13.11.2020 20:20
question
Mathematics, 13.11.2020 20:20
question
Mathematics, 13.11.2020 20:20
question
Social Studies, 13.11.2020 20:20
Questions on the website: 13722363